It is heated hot melt adhesive material melting state requires device flow glue temperature. The hot melt melter tank looks like a rectangular box, inside and outside the two layers of a combination of double-layer structure. The inner jacket is made of metal material melting tank, excellent thermal conductivity; the outer layer is made of angle steel and steel shell, supporting the molten pool. Four sidewalls and outer air layer, can be installed on the deck of the equipment and wires, but also as a heating bath insulation.
Vertical Cutting Machine for EPE Foam Sheet or Film from the box box, electric heating device, environmental hot melt thermometer and filter plate. The tank is usually made of aluminum alloy material, it is melting a certain volume of the cavity, the hot melt material; the upper opening of the slot, so that the hot melt material and solid, and with a cover, to prevent foreign matter into the molten bath. Environmental hot melt adhesive hot melt tank is set in the bottom of the heated electric heating device, hot melt box. The tank is equipped with a thermometer and temperature control device, the heating temperature can be adjusted automatically by the automatic temperature controller.
The heating and melting tanks can be divided into a smooth surface structure and two forms of meshing structure. Environmental hot melt adhesive pool surface treatment structure, the surface and the bottom of the surface is a smooth surface, the bottom of the tank is tilted low without exports, simple structure; hot melt adhesive cavity structure can be applied to any shape of molten solid.
The grid structure of the melting furnace, environmental hot melt adhesive four sides of the light curtain of the upper part of the opening, but also set the lid, but depends on the more complex structure, the lower part of the bar a number of ribs, Confluence of the hot melt glue separator at the bottom of each channel filter, into the exit low. The structure of the molten pool as a heat transfer area increases, greatly improving the thermal efficiency of the furnace, but a corresponding reduction in the effective area of the pool; In addition,Vertical Cutting Machine for EPE Foam Sheet or Film the shape of the size of the particles or bulk solid hot melt adhesive material has been limited.
In addition to the melt channel structure, some additional feed hoppers, environmentally friendly hot melt hopper hopper feed solid hot melt adhesive material. Large-scale composite structure design with pre-bath, hot-melt box and hot melt storage tank.
The cavity size of the hot bath should be based on the requirements of hot melt adhesive coating production to determine the basis. Environmental protection hot melt adhesive hot melt adhesive manufacturers professional painting equipment to produce a variety of specifications for customers to choose, including the small size of the pool capacity of 4kg,Vertical Cutting Machine for EPE Foam Sheet or Film pre-welding device capacity of up to 100 kg. Environmental hot melt adhesive melting power heating melting tank heater mainly depends on the melting temperature, melting coating requirements, work requirements, but also by coating hot melt liquid temperature and melt bath environmental factors such as heat dissipation.